Embperl::Mail uses Embperl to process a page template and send
the result out via EMail. Currently only plain text mails are supported. A later
version may add support for HTML mails. Because of that fact, normal Embperl
HTML processing is disabled per Default (see options below).
The Execute function can handle all the parameter that Embperl::Execute
does. Addtionaly the following parameters are recognized:  | from | | | gives the sender e-mail address |  | | | to | | | gives the recipient address(es). Multiply addresses can either be separated by semikolon
or given as an array ref. | | | | cc | | | gives the recipient address(es) which should receive a carbon copy. Multiply addresses can
either be separated by semikolon
or given as an array ref. | | | | bcc | | | gives the recipient address(es) which should receive a blind carbon copy. Multiply addresses can
either be separated by semikolon
or given as an array ref. | | | | subject | | | gives the subject line | | | | reply-to | | | the given address is insert as reply address | | | | mailheaders | | | Array ref of additional mail headers | | | | headerencoding (2.0b9+) | | | Tells Embperl::Mail which charset definition to include in any header
that contains character code 128-255 and therefore needs encoding.
Defaults to iso-8859-1. Pass
empty string to turn encoding of header fields of. | | | | mailhost | | | Specifies which host to use as SMTP server.
Default is localhost. | | | | mailhelo | | | Specifies which host/domain to use in the HELO/EHLO command.
A reasonable default is normally chosen by Net::SMTP, but
depending on your installation it may necessary to set it
manualy. | | | | maildebug | | | Set to 1 to enable debugging of mail transfer. | | | | options | | | If no options are given the following are used per default:
optDisableHtmlScan, optRawInput, optKeepSpaces, optReturnError | | | | escmode | | | In contrast to normal Embperl escmode defaults to zero (no escape) | | | | errors | | | As in Embperl::Execute you can specify an array ref, which returns
all the error messages from template processing. If you don't specify
this parameter Execute will die when an error occurs. | |
Some default values could be setup via environment variables. IMPORTANT: For now Embperl::Mail does not honour the Embperl
configuration directives in your httpd.conf. Only values set via the
environment are accepted (e.g. via SetEnv or PerlSetEnv).
Specifies which host to use as SMTP server.
Default is localhost.
Specifies which host/domain to use in the HELO/EHLO command.
A reasonable default is normally chosen by Net::SMTP, but
depending on your installation it may necessary to set it
manualy.
Specifies which the email address that is used as sender.
Default is www-server@server_name.
Debug setting for Net::SMTP. Default is 0.
|
